"Technical characteristics:
Dimensions (when folded): not more than 680 x 790 x 900 mm.
Weight: not more than 80 kg. Power supply: 220 V, 50 Hz.
Power consumption: not more than 350 W.
Description:
The set of training and laboratory equipment ""Computerized motor tester"" includes a full-function motor tester for gasoline (and partially diesel) ICE, a computer scanner for diesel and petrol vehicles and a database.
The kit supports diagnostics in the scan mode of the following brands VAZ (including cars Lada Granta), GM-AVTOVAZ, GAZ, UAZ, IZ, ZAZ, CEAZ with all existing electronic engine control systems (ESCD), including ABS, SRS (airbag) climate control, immobilizer, power steering, GROOVE, ZIL (Bosch EDC7UC31), MAZ (Bosch EDC7UC31, "Elara 50.3763 E3"), KAMAZ (Bosch MS6.1), BMW,CHEVROLET, CHERY,CITOEN, DAEWOO, FIAT, FORD GREAT WALL, HYUNDAI, KIA, NISSAN, MAZDA, OPEL, PEUGEOT, RENAULT, SUZUKI, TOYOTA, BYD, HAFEI, VAG Group vehicles, OBD-II diagnostic supported vehicles. Diagnostic systems:
Ignition system
Determination of the status of candles and candle wires (carbon, breakage, breakage);
determination of operating modes and faults of the ignition coil (inter-turn closures, whether connected correctly, breakdowns);
diagnostics of switch and hall sensor;
Viewing the performance of the centrifugal regulator (graph of UZ dependence on revolutions);
Definition of PES (without or with strobe scope)
Fuel Supply System for Gasoline Engines
Electric testing of fuel injectors (winding inter-turn, injection phase duration);
Monitoring of sensors (temperature, throttle position, oxygen sensor, DMR air mass flow sensor, etc.);
inspection of the actuating mechanisms (idling regulator, etc.);
exhaust gas composition (with external gas analyzer);
Determination of cylinder input by off ignition
Diesel engine fuel supply system** mDiagnosis of the status of the high-pressure fuel pump of the HPFP and injectors according to the nature of the pressure pulsation curve in fuel pipes;
Determination of injection angles (with or without stroboscope);
view centrifugal regulator performance (injection angle-to-speed graph);
Electrical inspection of fuel injector control channels.
Diesel engine pre-heating system**
diagnostics of candle chains or incendiary candle.
gas distribution system
evaluation of relative cylinder compression in starter scrolling mode;
Compression measurement in dynamic and scrolling mode;
Determination of the correct installation of the timing belt;
valve operation monitoring
Power and charging system
Verification of the operation of the generator and the battery charging system (output voltage and generator current with detection of malfunctions of rectifying diodes, relay regulator, hanging brushes, etc.).
Additional features
multi-channel oscilloscope mode with synchronization from any of the channels or from special synchronization channels (crankshaft sensor, inductive mites as sensor of the first cylinder) or recorder. Display up to 8 channels on the screen with recording capability.
** In order to perform the study of these characteristics, an additional set of parts, individually selected from the diesel engine type, is supplied optionally.
Supply Set:
Personal computer.
Monitor.
The lab table with the boxes.
Automotive diagnostic unit
An uninterrupted power supply.
Keyboard.
Mouse.
Passport.
Operating manual.
Line filter."
